NMR investigation of concentrated alumina and silica slurries

The longitudinal relaxation times (T₁) of water in concentrated silica and alumina slurries were measured as a function of solids content. It was shown that the results could be fit very well with a two-phase fast-exchange model between free and surface-bound water. As expected, values of T₁ for bound water were in the order of 20–2000 times lower than that for free water, indicating a higher effective viscosity of the surface-bound water. The strength of the interaction depended on the particular surface, and all of the aluminas examined interacted more strongly with water than the two silicas studied, which themselves differed considerably. The chemical mechanical polishing (CMP) removal rate of tantalum by silica slurries was shown to be directly correlated with the interaction parameters, derived from the NMR relation times rather than with total surface hydroxyl group concentration.     

0.8W/80K直线驱动斯特林制冷机的研制

介绍了一种 0 .8W/ 80 K分置式斯特林制冷机。该制冷机采用当前国外先进的直线电机驱动 ,双活塞对称布置结构。该制冷机已通过军品所要求的环境试验 ,输入功率小于 4 0 W(DC)情况下 ,其 +6 0℃高温环境下制冷量≥ 0 .5 W/ 80 K ,带载 0 .5 W工况下 MTTF已突破 2 0 0 0小时。文中主要论述了其工作原理、结构特点、试验情况。     

薄膜外延生长的计算机模拟

以Cu膜为例，用Monte-Carlo算法模拟了薄膜生长的随机过程，并提出了更加完善的模型.在合理选择原子间相互作用计算方法的基础上，考虑了原子的吸附、在生长表面的迁移及迁移所引起的近邻原子连带效应、从生长表面的脱附等过程.模拟计算了薄膜的早期成核情况以及表面粗糙度和相对密度.结果表明，随着衬底温度的升高或入射率的降低，沉积在衬底上的原子逐步由离散型分布向聚集状态过渡形成一些岛核，并且逐步由二维岛核向三维岛核过渡.在一定的原子入射率下，存在三个优化温度，成核率最高时的最大成核温度Tn、薄膜的表面粗糙度最低 关键词： Monte-Carlo算法 计算机模拟 薄膜生长     

多目标优化发射层析算法在等离子体场光谱诊断中的应用

提出一种基于多目标优化原理的发射光谱层析(EST)图像重建新算法MCIRT.通过计算机数值 模拟，考察了该算法对非对称发射系数场分布的重建效果.结果表明，与传统层析算法相比 ，MCIRT算法具有收敛快，重建精度高的优势，适合于非完全数据情况下的等离子体发射系 数场重建，并且实时性更好.作为一个应用实例, 运用谱线相对强度法重建了自由电弧等离 子体的三维温度及粒子数密度分布. 关键词： 等离子体诊断 图像重建     

p型导电掺In的SnO2薄膜的制备及表征

采用溶胶-凝胶提拉法成功地制备了p型导电掺In的SnO2薄膜.x射线衍射测试结果表明，掺In的SnO2薄膜保持SnO2的金红石结构.吸收谱测试结果表明，掺In的SnO2禁带宽度为3.8eV.霍尔测量结果表明，空穴浓度与热处理温度有很大的关系，525℃为最佳热处 理的温度.铟锡原子比在0.05—0.20范围内，空穴的浓度与In的含量有直接的关系，并随In含量的增加而增加. 关键词： SnO2 溶胶-凝胶法 p型导电     

A Novel Model for Protein Immobilization on Microspheres

The immobilization of proteins, especially receptor proteins commonly used in high through-put screening of drugs (HTS), have received great attention in recent years. There are many successful isothermal models for describing the adsorption of protein onto solid surface, such as Langmuir model, Bi-Langmuir model, Fowler model, Freundlich model, Freundlich-Langmuir model and Tekmin model etc. In all these models, Langmuir model was the most favorable one model accepted by many researchers, but the experimental results showed that it was not entirely fit to all adsorption behaviors. So new models were required for describing protein adsorption onto microspheres in different conditions.In our research, a novel isothermal model, including Langmuir and other adsorbing behaviors was presented basing on the holding degree of surface active sites and the interaction styles of protein immobilization. In Langmuir model, the adsorbing amount of protein was described as [PS] =Km[P]/1 + K[P], where [PS] was the concentration of adsorbed protein, [P] was the concentration of freeprotein at equilibrium state, and Km and K was constant. According to the interactions of protein and ligands, there were three patterns in the interactions of protein and ligands. On the similar assumption that the interaction of protein and microspheres were three styles, and based on the definition of the holding degree of surface active sites (Y), three adsorption behaviors could be described as Y K[ P ]φ/ K[P]φ+1 or ln K + φ ln[P] =ln(Y/1-Y) in which [P] was the concentration of free protein at equilibrium state, and φ and K was constant. Different scale of φ presented different adsorption behaviors, especially when φ was 1, the adsorption behavior was Langmuir adsorbing model. Figure I indicated the different adsorbing results in different adsorption behaviors (φ＞1, φ＜1,and φ=1).     

Stability Conditions of the MMAP [ K ]/ G [ K ]/1/ LCFS Preemptive Repeat Queue

In this paper, we study the stability conditions of the MMAP[K]/G[K]/1/LCFS preemptive repeat queue. We introduce an embedded Markov chain of matrix M/G/1 type with a tree structure and identify conditions for the Markov chain to be ergodic. First, we present three conventional methods for the stability problem of the queueing system of interest. These methods are either computationally demanding or do not provide accurate information for system stability. Then we introduce a novel approach that develops two linear programs whose solutions provide sufficient conditions for stability or instability of the queueing system. The new approach is numerically efficient. The advantages and disadvantages of the methods introduced in this paper are analyzed both theoretically and numerically.     

关于群胚作用和李双代数胚态射

在这篇文章中，我们讨论了李双代数胚之间的态射，得到了一些李双代数胚之间态射的性质．研究了泊松群胚在泊松流形上的泊松作用，以及这个泊松作用与被作用流形的切李双代数胚到作用泊松群胚的切李双代数胚之间的态射的关系，得到了一些有用的结论。     

微模塑法制备PMMA/SiO2二氧化硅杂化材料微结构

以摩尔比为 1∶1的甲基丙烯酸甲酯 (MMA)、甲基丙烯酸 (3 三乙氧基硅烷基 )丙酯 (ESMA)单体、0 .2 %(单体总量的质量分数 )的偶氮二异丁腈AIBN引发剂和四氢呋喃 (THF)溶剂 ,及 2 0 % (总质量分数 )的正硅酸乙酯TEOS合成出PMMA/SiO2 有机 无机杂化的杂化溶胶 .将溶胶在洗净的普通光学玻璃基片表面甩膜 .利用软刻蚀中的微模塑法 ,把有机硅弹性印章复制有精细图纹一面轻放在杂化溶胶膜上进行微模塑 ,外加 1N压力于12 0℃下处理 2h使溶胶凝胶化 .印章剥离后在基片表面就形成了PMMA/SiO2 有机 无机杂化材料的微图纹结构 .从微图纹的光学显微镜照片可以看出微模塑方法制备杂化材料复制的图纹精细度高 ,操作简单易行 ,是一类比较理想的微细图纹结构加工的方法 .     

ON THE UNIQUENESS OF LIMIT CYCLE FOR A GENERALIZED LINARD SYSTEM

１．ＲｅｃｅｎｔｌｙｔｈｅｒｅａｒｅｓｏｍｅｇｏｏｄｌｉｔｅｒａｔｕｒｅｓｃｏｎｃｅｒｎｉｎｇｔｈｅｕｎｉｑｕｅｎｅｓｏｆｌｉｍｉｔｃｙｃｌｅｓｆｏｒｇｅｎｅｒａｌｉｚｅｄＬｉéｎａｒｄｓｙｓｔｅｍｓｘ＝φ（ｙ）－Ｆ（ｘ），ｙ＝－ｇ（ｘ），（Ｆ（ｘ）...